Chipanalog CA-IF1145FDF-Q1 Interface IC

Chipanalog CA-IF1145FDF-Q1

The CA-IF1145 devices are robust high-speed, low-power control area network (CAN) transceivers with integrated protection for automotive applications. These devices meet the requirements ISO1189-2:2016 and SAE J2284-1 to SAE J2284-5 physical layer standards. All devices feature up to ±42V extended fault protection on the data transmission lines in all operation modes. The CA-IF1145 devices can operate in different modes: normal operation, overtemperature protection mode, and standby, sleep, off modes for low current consumption, as well as wake-up capability over CAN bus or via the local WAKE pin. A selective wake-up (FD-passive) is able to ignore CAN FD(flexible data rate) frames while waiting for a valid wake-up frame in sleep or standby modes to support ISO 11898-2:2016 compliant CAN partial networking and enables reliable communication in the CAN FD networks up to 5 Mbit/s data rates. Inhibit output (INH) can be used to control one or more external voltage regulators presented on a node to reduce the battery power consumption at system level. The CA-IF1145 features ideal passive behavior when unpowered, all bus terminals are high impedance during power-off. These make the CA-IF1145 ideal in the applications that all nodes are always connected to the power supply line, because the transceivers can be active only as required to minimize system current consumption. The CA-IF1145 series devices include a dominant timeout detection to prevent bus lockup caused by controller error or by a fault on the TXD input. Also, the CA-IF1145 devices feature individual logic supply input (VIO) and provide low level translation to simplify the interface with low voltage CAN controllers. SPI-compatible interface is available for transceiver operation control and status information reading.

Features

• Meets the requirements of ISO 11898-2:2016 and SAE J2284-1 to SAE J2284-5 physical layer standards
• Optimized for high-speed CAN communication and CAN FD tolerance enables CAN FD data transmission up to 5 Mbit/s
• Supports selective wake to wake-up partial networking nodes
• CAN bus pins short-circuit protection to ±42 V, ideal for 12V battery systems
• 2.85V to 5.5V logic-supply (VIO) range easy to interface with 3.3V and 5.0V logic
• Autonomous bus biasing
• Advanced ECU power management
• INH output can be used to turn-off entire node to reduce power consumption
• Low-power standby and sleep modes support both remote wake-up and local wake-up
• Remote wake-up via standard CAN wake-up pattern(WUP) or selective wake-up frame (WUF) according to ISO 11898-2:2016
• Selective wake supports 50 kbit/s, 100 kbit/s, 125 kbit/s, 250 kbit/s, 500 kbit/s and 1 Mbit/s CAN bit-rate
• Local wake-up via WAKE terminal, also local wake-up can be disabled to reduce power consumption
• Wake-up sources identification
• –55°C to 150°C junction temperature range
• Available in SOIC14 and DFN14 packages

Applications

• Body electronics
• In-car entertainment systems
• Hybrid, electric and power train system
• Smart ADAS
• Chassis systems

Device Information

Download Datasheet (PDF)