CRM25T07E1 CR Micro 250V 7A IPM SOP-23A

The CR Micro CRM25T07E1 is a 250 V 7 A intelligent power module in a SOP-23A package, wired as a 3-phase full bridge using MOSFET power stages. Protection on board covers under-voltage lockout. Designed for Fans and Pumps.

Key Specifications

Applications

Fans and Pumps — the module's rating and package are sized for this class of load.

Selection Notes

• The module integrates gate drive and protection. The input side expects logic-level PWM, not a raw gate signal — do not add an external driver.
• Fault output is open-drain on most of these modules. Fit a pull-up and latch it in the controller, otherwise the module restarts into a fault.
• Check the dead time and minimum pulse width in the datasheet. The internal interlock is a protection layer, not a substitute for correct timing.
• Thermal design dominates reliability. Use the module's internal thermistor or the case-to-heatsink path to size the heatsink for the actual switching loss.

Common Questions

What topology does the CRM25T07E1 implement?

It is a 3-phase full bridge module rated 250 V / 7 A.

What protection is built into the CRM25T07E1?

The module integrates under-voltage lockout. External fault handling still has to latch the fault signal and sequence a safe restart.

What applications is the CRM25T07E1 intended for?

Fans and Pumps — a match for the module's power rating and package thermal path.

What package does the CRM25T07E1 come in?

SOP-23A. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.