CRSM014N03L2 CR Micro 30V 240A N-Channel MOSFET PDFN5×6

The CR Micro CRSM014N03L2 is a 30 V 240 A N-channel MOSFET in a PDFN5×6 package, built on the SGT process. On-resistance is 1 mΩ typical and 1.4 mΩ maximum at a 10 V gate drive; 1.53 mΩ typical at 4.5 V, so it also works from a logic-level driver; gate charge is 48.7 nC with 3026 pF input capacitance; threshold voltage spans 1.2 to 2.2 V.

Key Specifications

Same-Rating Selection Table

17 part numbers share the same 30 / PDFN5×6 / N rating — sorted by rds(on) typ.

Process Technology

SGT (Shielded Gate Trench) — a trench gate with a grounded shield electrode beneath it. The shield cuts the gate-drain capacitance, so Qg and Crss drop sharply against a conventional trench at the same Rds(on). This is the workhorse process for 30–200 V and for 600–650 V high-frequency switching.

Applications

Low-voltage DC-DC converters, load switches, battery protection, and brushed or stepper motor drive.

Selection Notes

• Rds(on) rises with junction temperature. Size the heatsink against the hot value given in the datasheet, not the 25 °C number in the table above.
• If the gate is driven below 10 V, check the 4.5 V Rds(on) line — parts without that rating are not characterised for logic-level drive.
• For high-frequency stages compare Qg and Ciss against the Rds(on) gain. A part one bin lower in Rds(on) often costs more switching loss than it saves in conduction.
• The body diode recovery of low-Rds(on) parts can be severe in bridge topologies. Verify dv/dt and dead time against the datasheet before dropping it into a half bridge.

Common Questions

Is the CRSM014N03L2 an N-channel or P-channel device?

It is N-channel. The drain-source rating is 30 V.

Can the CRSM014N03L2 be driven from a 4.5 V logic-level gate signal?

Yes. The datasheet characterises Rds(on) at 4.5 V: 1.53 mΩ typical and 1.91 mΩ maximum.

What is the gate threshold voltage of the CRSM014N03L2?

VGS(th) is specified between 1.2 and 2.2 V. Below the lower figure the part is off; above the upper figure it is fully on at the rated current.

How much gate charge does the CRSM014N03L2 need?

Qg is 48.7 nC. Size the driver against that figure at your switching frequency, and add the gate loop loss to the total dissipation budget.

What package does the CRSM014N03L2 come in?

PDFN5×6. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 17 part numbers in this rating group?

All 17 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.