CRTT500P10L CR Micro -100V -27A P-Channel MOSFET TO-220

The CR Micro CRTT500P10L is a -100 V -27 A P-channel MOSFET in a TO-220 package, built on the Trench process. On-resistance is 42 mΩ typical and 50 mΩ maximum at a 10 V gate drive; gate charge is 80 nC with 4828 pF input capacitance; threshold voltage spans -1.3 to -2.5 V.

Key Specifications

Same-Rating Selection Table

2 part numbers share the same -100 / TO-220 / P rating — sorted by rds(on) typ.

Process Technology

Trench — the gate is etched vertically into the drift region, multiplying channel width per unit area. Lowest Rds(on) in the sub-200 V range; the trade-off is higher Qg and a more fragile body diode under hard commutation.

Applications

Low-voltage DC-DC converters, load switches, battery protection, and brushed or stepper motor drive.

Selection Notes

• Rds(on) rises with junction temperature. Size the heatsink against the hot value given in the datasheet, not the 25 °C number in the table above.
• If the gate is driven below 10 V, check the 4.5 V Rds(on) line — parts without that rating are not characterised for logic-level drive.
• For high-frequency stages compare Qg and Ciss against the Rds(on) gain. A part one bin lower in Rds(on) often costs more switching loss than it saves in conduction.
• The body diode recovery of low-Rds(on) parts can be severe in bridge topologies. Verify dv/dt and dead time against the datasheet before dropping it into a half bridge.

Common Questions

Is the CRTT500P10L an N-channel or P-channel device?

It is P-channel. The drain-source rating is -100 V.

Can the CRTT500P10L be driven at 4.5 V?

No 4.5 V on-resistance figure is published for this part. It is characterised at 10 V gate drive, so use a driver that reaches 10 V.

What is the gate threshold voltage of the CRTT500P10L?

VGS(th) is specified between -1.3 and -2.5 V. Below the lower figure the part is off; above the upper figure it is fully on at the rated current.

How much gate charge does the CRTT500P10L need?

Qg is 80 nC. Size the driver against that figure at your switching frequency, and add the gate loop loss to the total dissipation budget.

What package does the CRTT500P10L come in?

TO-220. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 2 part numbers in this rating group?

All 2 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.