CS45N25A0R-G CR Micro 250V 45A N-Channel MOSFET TO-263

The CR Micro CS45N25A0R-G is a 250 V 45 A N-channel MOSFET in a TO-263 package, built on the Planar process. On-resistance is 72 mΩ typical and 85 mΩ maximum at a 10 V gate drive; gate charge is 55.5 nC with 2883 pF input capacitance; threshold voltage spans 2.5 to 4.5 V.

Key Specifications

Same-Rating Selection Table

2 part numbers share the same 250 / TO-263 / N rating — sorted by rds(on) typ.

Process Technology

Planar — the gate sits flat on the die surface. Lower channel density than trench designs, but a wider safe operating area, stronger avalanche withstand and simpler gate drive. Preferred for high-voltage and rugged industrial loads where robustness outranks on-resistance.

Applications

Telecom and server DC-DC stages, Class-D audio, PoE interfaces, and 48 V motor drive.

Selection Notes

• Rds(on) rises with junction temperature. Size the heatsink against the hot value given in the datasheet, not the 25 °C number in the table above.
• If the gate is driven below 10 V, check the 4.5 V Rds(on) line — parts without that rating are not characterised for logic-level drive.
• For high-frequency stages compare Qg and Ciss against the Rds(on) gain. A part one bin lower in Rds(on) often costs more switching loss than it saves in conduction.
• The body diode recovery of low-Rds(on) parts can be severe in bridge topologies. Verify dv/dt and dead time against the datasheet before dropping it into a half bridge.

Common Questions

Is the CS45N25A0R-G an N-channel or P-channel device?

It is N-channel. The drain-source rating is 250 V.

Can the CS45N25A0R-G be driven at 4.5 V?

No 4.5 V on-resistance figure is published for this part. It is characterised at 10 V gate drive, so use a driver that reaches 10 V.

What is the gate threshold voltage of the CS45N25A0R-G?

VGS(th) is specified between 2.5 and 4.5 V. Below the lower figure the part is off; above the upper figure it is fully on at the rated current.

How much gate charge does the CS45N25A0R-G need?

Qg is 55.5 nC. Size the driver against that figure at your switching frequency, and add the gate loop loss to the total dissipation budget.

What package does the CS45N25A0R-G come in?

TO-263. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 2 part numbers in this rating group?

All 2 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.