CS7N65ARR CR Micro 650V 7A N-Channel MOSFET TO-262

The CR Micro CS7N65ARR is a 650 V 7 A N-channel MOSFET in a TO-262 package, built on the Planar process. On-resistance is 1200 mΩ typical and 1400 mΩ maximum at a 10 V gate drive; gate charge is 24 nC with 1130 pF input capacitance; threshold voltage spans 2 to 4 V.

Key Specifications

Same-Rating Selection Table

5 part numbers share the same 650 / TO-262 / N rating — sorted by rds(on) typ.

Process Technology

Planar — the gate sits flat on the die surface. Lower channel density than trench designs, but a wider safe operating area, stronger avalanche withstand and simpler gate drive. Preferred for high-voltage and rugged industrial loads where robustness outranks on-resistance.

Applications

Active PFC, server and telecom rectifiers, and half-bridge or full-bridge DC-DC with 650 V bus.

Selection Notes

• Rds(on) rises with junction temperature. Size the heatsink against the hot value given in the datasheet, not the 25 °C number in the table above.
• If the gate is driven below 10 V, check the 4.5 V Rds(on) line — parts without that rating are not characterised for logic-level drive.
• For high-frequency stages compare Qg and Ciss against the Rds(on) gain. A part one bin lower in Rds(on) often costs more switching loss than it saves in conduction.
• The body diode recovery of low-Rds(on) parts can be severe in bridge topologies. Verify dv/dt and dead time against the datasheet before dropping it into a half bridge.

Common Questions

Is the CS7N65ARR an N-channel or P-channel device?

It is N-channel. The drain-source rating is 650 V.

Can the CS7N65ARR be driven at 4.5 V?

No 4.5 V on-resistance figure is published for this part. It is characterised at 10 V gate drive, so use a driver that reaches 10 V.

What is the gate threshold voltage of the CS7N65ARR?

VGS(th) is specified between 2 and 4 V. Below the lower figure the part is off; above the upper figure it is fully on at the rated current.

How much gate charge does the CS7N65ARR need?

Qg is 24 nC. Size the driver against that figure at your switching frequency, and add the gate loop loss to the total dissipation budget.

What package does the CS7N65ARR come in?

TO-262. Check the datasheet mechanical drawing for lead spacing and thermal pad dimensions before laying out the footprint.

How do I choose between the 5 part numbers in this rating group?

All 5 share the same voltage and package class. Sort by on-resistance first, then check gate charge: the lowest Rds(on) part is not automatically the best choice if the stage switches at high frequency. The table above lists them in ascending Rds(on) order.