
The CC12H4.5A-TR is the 4.5 A part of the CC12H4.5A family - 1206 (3216 metric) surface mount chip rated 32 Vdc with 100 A interrupting capacity.
| Parameter | Value |
|---|---|
| Manufacturer / Series | Eaton / CC12H Series |
| Orderable part number | CC12H4.5A-TR |
| Current rating | 4.5 A |
| Voltage rating | 32 Vdc |
| Interrupting rating | 100 A @ 32 Vdc |
| Typical DC cold resistance | 28 mΩ |
| Typical pre-arcing I²t | 4.2 A²s (at 10 In) |
| Typical voltage drop | 160 mV |
| Part marking | X |
| Package | 1206 (3216 metric) surface mount chip, ceramic body |
| AEC-Q200 | qualified (750 mA to 30 A range) |
| Agency / environmental | cURus recognition file E19180, guide JDYX2 / JDYX8; RoHS, halogen free, lead free |
| % of rating / condition | Opening time |
|---|---|
| 100 % | 4 hours minimum |
| 200 % (1-3 A) | 1.0 s - 60 s |
| 250 % (1-5 A) | 5 s maximum |
| 300 % (1-5 A) | 0.1 s - 3.0 s |
| 350 % (250-750 mA, 6-30 A) | 5 s maximum |
On the DC side 4.5 A is sized from the continuous battery or bus current plus the ambient derating, not from a branch-circuit rule of thumb. Check the prospective short-circuit current against the breaking capacity in the table before fixing the rating.
CC12H4.5A-TR; the packaging prefix, where the series uses one, goes in front of the part number rather than after it.Will CC12H4.5A-TR carry 4.5 A continuously without opening?
Yes. The published table shows no opening at 100 % of rating, so 4.5 A is inside the continuous rating at 25 C. Ambient temperature inside the enclosure, not the nominal current, is what usually forces the next size up.
What fault current can CC12H4.5A-TR clear?
100 A at rated voltage. That figure assumes a normal branch-circuit source impedance; a stiff transformer feeding the same circuit can exceed it, and then the fuse is no longer the protective device by design.
Can CC12H4.5A-TR replace the next rating up in an existing design?
No. Dropping from a higher rating changes both the continuous headroom and the I2t, so a fuse that used to ride through inrush may now open on it. Match current, voltage, I2t and body before substituting.
Design note: resistance, I2t and voltage-drop values are typical unless identified as ratings. Verify the current data sheet and curves before release.

Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd