
| Parameter | Value |
|---|---|
| Orderable part number | CLH1110R1-6-R050-R |
| Number of phases | 6 |
| Rated inductance per phase | 50 nH ±20% |
| Open circuit inductance (OCL) | 300 nH typical / 240 nH minimum |
| Full load inductance (FLL) | 200 nH minimum |
| DC resistance (DCR) | 0.23 mOhm |
| Rated current per phase | 25 A |
| Peak current per phase | 140 A |
| Package | CLH1110 footprint (see drawing) |
| Packaging | TR - tape and reel |
| RoHS | Compliant (-R suffix) |
With 6 phases of 50 nH each, the ripple on a given rail is the sum of the individual phase currents. Adding phases does not just divide the current - it also shapes the ripple, which is why the phase count is part of the VRM design rather than a purchasing decision.
Copper loss rises with temperature - roughly half the DCR change over the working range. A part running hot is a part with more loss, which is a feedback loop worth keeping an eye on in a densely populated board.
CLH1110R1 是 R1 版 50 nH 多相电感,OCL 300 nH,DCR 低到 0.23 mOhm。
OCL is the open-circuit inductance: 300 nH typical / 240 nH minimum measured with no DC bias. In the circuit the core is biased by the phase current and the inductance falls - the datasheet gives FLL as the value at rated current, and that is the number to use for ripple calculation. 6 phases is a high-current configuration. Per-phase current is low enough that copper loss stays small even with 25 A in each winding, which is the whole point of going to this many phases.
Can I use fewer phases than the part number?
No. The part number fixes the phase count and the pinout that goes with it.
How do the phases connect?
The datasheet gives the pin numbering for each phase pair - (3-4)(5-6) and so on - and the layout has to keep each phase current loop tight.
Can I use fewer phases than the part number?
No. The part number fixes the phase count and the pinout that goes with it.
Design note: use the full-load inductance and the hot-case
DCR for the loss budget, and check the layout keeps each phase current loop closed.

Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd