Eaton CMLA0907-701-R Surface-Mount Common-Mode Choke
Eaton CMLA0907-701-R Surface-Mount Common-Mode Choke

Eaton CMLA0907-701-R Surface-Mount Common-Mode Choke

Share
Eaton CMLA0907-701-R: 700 ohm common-mode inductor, 5 A rated, 125 Vdc, 10 x 7.5 x 4.8 mm max.
    • Product Details
    • Download

    Eaton CMLA0907-701-R Surface-Mount Common-Mode Choke

    CMLA0907-701-R: common-mode choke, 700 ohm, DCR 10 mOhm, 10 x 7.5 x 4.8 mm max.

    Electrical Specifications

    ParameterValue
    Orderable part numberCMLA0907-701-R
    Common-mode impedance700 ohm typical, 500 ohm minimum
    DCR maximum10 mOhm
    Rated current5 A
    Rated voltage125 Vdc
    Withstanding voltage125 Vdc
    Insulation resistance10 Mohm minimum
    Package10 x 7.5 x 4.8 mm max
    RoHSCompliant (-R suffix)

    Reading the Data Sheet

    The impedance figure is measured across the winding pair, which is exactly the common-mode path. That is why these parts are picked by impedance at the noise frequency rather than by inductance.

    Interwinding capacitance is the mechanism behind the high-frequency behaviour: above the capacitance the choke stops blocking and starts passing. Leakage inductance is the part of the inductance that escapes the core and does not help.

    Where This Series Fits

    CMLA 是车规共模噪声抑制芯片电感,700 Ohm 典型,电流 4–8 A。

    • Typical use: 汽车 12 V 电源线、动力总成供电线滤波.
    • 车规件除了阻抗还要看额定电流:同样的阻抗,电流越大体积越大,DCR 越低。
    • Data sheet 4315.

    Rated voltage 125 Vdc and 10 Mohm insulation resistance are what make this usable on an automotive bus: the part has to survive the transients and the isolation test without leaking current into the signal.

    Frequently Asked Questions

    Does it affect my signal?
    Only through DCR and the small amount of leakage inductance. The differential signal is not filtered by design.

    Does it affect my signal?
    Only through DCR and the small amount of leakage inductance. The differential signal is not filtered by design.

    What impedance should I pick?
    The one that gives the attenuation you need at the noise frequency of your circuit, then check that the DCR is acceptable on the signal.

    Design note: pick the choke by impedance at the noise
    frequency, then confirm DCR and rated current against the signal or the rail.

    Mechanical Dimensions

    eaton-cmla-automotive-common-mode-noise-suppressor-chip-inductor-data-sheet mechanical dimensions and recommended pad layout

    Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products