Eaton DRQ73-R33-R - Dual Winding 0.33 uH Power Inductor
Eaton DRQ73-R33-R - Dual Winding 0.33 uH Power Inductor

Eaton DRQ73-R33-R - Dual Winding 0.33 uH Power Inductor

Share
Eaton DRQ73-R33-R: Dual Winding Shielded Drum Core Inductor, 0.33 uH, 6.19 A, DCR 7.4 mOhm.
    • Product Details
    • Download

    Eaton DRQ73-R33-R - Dual Winding 0.33 uH Power Inductor

    DRQ73-R33-R at a glance: dual-winding shielded drum core, 0.33 uH per winding, 6.19 A, DCR 7.4 mOhm.

    Electrical Specifications

    ParameterValue
    Orderable part numberDRQ73-R33-R
    Rated inductance0.33 uH ±20%
    Open circuit inductance (OCL)0.31 uH
    Irms (40 °C rise)6.19 A
    Isat14.4 A
    DCR typical @ 20 °C7.4 mOhm
    Volt-microsecond rating1.98 V-us
    Series connection1.22 uH, 3.1 A
    Parallel connection0.33 uH, 6.19 A
    Turns ratio1:1, coupled
    Package7.6 x 7.6 mm footprint, 3.55 mm max height
    MountingSurface mount
    Operating temperature-40 °C to +125 °C
    QualificationCommercial grade
    RoHSCompliant (-R suffix)

    The Figures Explained

    The DRQ/DRAQ construction puts two windings on a shielded drum core with a defined 1:1 turns ratio. That ratio is what makes the part useful as a transformer: the two windings share flux, so the magnetising current is common and the ripple can be made to cancel.

    Coupled operation is where the part earns its keep: with the right duty cycle the two windings cancel part of the ripple, so the output capacitor sees less AC current and the converter can run at a lower switching frequency for the same ripple.

    The saturation current is measured at a defined roll-off, and Eaton states the percentage on the data sheet: Isat is the peak current for approximately 30% rolloff at +20 °C. Read the number with the percentage in hand, because "saturation" means different things at 25% and at 40%.

    Positioning in the Range

    DRQ73 is a dual-winding drum core: two identical windings on one core that can be wired in parallel for a low-inductance high-current choke, in series for four times the inductance, or used as a 1:1 coupled inductor or transformer. Same 7.6 mm pad as the single-winding DR73.

    • Typical applications: Buck and boost stages, SEPIC and flyback transformers, output filters, LCD panels, portable devices.
    • The two windings are isolated to 200 Vac only - this is a functional barrier for circuit reasons, not a safety isolation rating.
    • Data sheet DS4311.

    Design Notes

    At 0.33 uH this part is at the low end of the family. The winding that produces that inductance is also what sets the 7.4 mOhm DCR - more turns, thinner wire, more resistance.

    Thermal design is not optional here. The rated current assumes a 40 °C rise with the part in free air on a stated pad; inside a closed box, on a thin board, next to a hot IC, that assumption is gone.

    Frequently Asked Questions

    Does the coupling ratio matter?
    Yes. The turns ratio is 1:1, and the ripple cancellation depends on it. A part with a different ratio is not interchangeable in a coupled design.

    How much isolation is there between windings?
    The data sheet states the winding-to-winding voltage for each family. Treat it as a functional rating, not as reinforced insulation for a mains barrier.

    How much isolation is there between windings?
    The data sheet states the winding-to-winding voltage for each family. Treat it as a functional rating, not as reinforced insulation for a mains barrier.

    Design note: decide the connection before you lay out the board. Parallel, series and coupled all use the same part, and the inductance moves by 4x between them.

    Mechanical Dimensions

    eaton-drq-shielded-drum-core-power-inductors-data-sheet mechanical dimensions and recommended pad layout

    Dimensional drawing and recommended PCB pad layout from the Eaton data sheet. Tolerances and pad dimensions are as printed on the drawing; check the outline against your layout before release.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products