
| Parameter | Value |
|---|---|
| Orderable part number | ECSTA1V0703-1100-R |
| Turns ratio secondary:primary | 100:1 |
| Secondary inductance minimum | 1330 uH |
| DCR secondary maximum | 10.7 Ohm |
| DCR primary reference | 1.5 mOhm |
| Hi-pot primary to secondary | 500 Vac |
| Sensed current maximum | 9 A |
| Package | 7.2 x 5.2 x 3 mm |
| Mounting | Surface mount |
| Operating temperature | -40 C to +125 C |
| Qualification | AEC-Q200 |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1190 |
Outline drawing, winding arrangement and recommended pad layout are on
page 2 of Eaton Technical Data ELX1190; the package line above gives the body size where
the data sheet states it.
A current sense transformer measures the current in a primary conductor by stepping it down into a burden resistor. The turns ratio sets the scaling, the secondary inductance sets how low in frequency the part still works, and the secondary DCR sets how much of the signal is lost before the resistor sees it.
With a 100:1 ratio, a 10 A primary current becomes 0.1 A in the secondary. Across a 50 ohm burden that is 5 V, which is what the controller actually sees.
The secondary winding of 1330 uH with 10680 mOhm of resistance sets both the low-frequency corner and the signal loss; both move if you change the burden resistor.
Within the ECSTA1V0703 family this is item 4 of 5 in the Eaton catalogue.
The ECST and ECSTA ranges cover 7 A to 15 A of primary current in EE4.4 to EE8.3 packages, with turns ratios from 20:1 to 200:1.
What defines the low-frequency limit?
The secondary inductance and the burden resistance form a high-pass corner. Below it the output droops, which is why the inductance is quoted at a stated test frequency.
Why must the secondary be terminated?
The part is a current source. Left open, the secondary voltage rises until the core saturates or the insulation breaks down; the burden resistor is part of the circuit, not an optional extra.
What turns ratio do I need?
Pick the ratio so the secondary current into the burden resistor gives the voltage the controller expects at the current you want to measure. Higher ratios give more resolution but more secondary inductance and DCR.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd