Eaton LD2-1R0-HV 1.0 uH Radial Inductor 15 mOhm
Eaton LD2-1R0-HV 1.0 uH Radial Inductor 15 mOhm

Eaton LD2-1R0-HV 1.0 uH Radial Inductor 15 mOhm

Share
LD2-1R0-HV: metalized drum core inductor, 1.0 uH ±30%, – A, Isat 6 A, DCR 15 mOhm.
    • Product Details
    • Download

    Eaton LD2-1R0-HV 1.0 uH Radial Inductor 15 mOhm

    LD2-1R0-HV at a glance: metalized drum core inductor, 1.0 uH ±30%, – A, Isat 6 A, DCR 15 mOhm.

    Ratings at a Glance

    ParameterValue
    Orderable part numberLD2-1R0-HV
    Inductance1.0 uH ±30%
    DCR maximum @ +25 °C15 mOhm
    Isat6 A
    FLL minimum (at Isat)0.56 uH
    Impulse test voltage1100 V
    Hi-pot test voltage1000 V
    MountingThrough-hole
    Operating temperature-25 °C to +125 °C
    QualificationCommercial grade
    RoHSCompliant, -R suffix
    Data sheetEaton Technical Data ELX1200

    Mechanical Drawing

    LD2-1R0-HV mechanical dimensions and pad layout

    Drawing reproduced from Eaton Technical Data ELX1200: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.

    What the Numbers Mean

    The drum geometry concentrates the field in the core but leaves the ends open, so the inductance depends on the surroundings more than a shielded part would. That is acceptable in the applications these parts serve – filters, bias supplies, low current DC-DC stages – where the board is not densely packed.

    Saturation is reached at 6 A. Beyond that point the inductance falls on the soft part of the curve, and the converter’s ripple grows faster than the load current does.

    Within the LD2 family this is value 1 of 41, in a range that runs from 1 to 2200 uH.

    Where This Series Fits

    The drum core family covers about 1 µH to tens of microhenry in axial, radial and surface-mount bodies. It is the value range between the chip inductors and the large toroids.

    • The open magnetic path means nearby metal changes the inductance. Keep the specified clearance to shields and screws.
    • Typical applications: ac/dc direct buck converters; smart water heaters; smart home/kitchen appliances; smart heating systems/pumps; iot devices power converters.
    • Design note: the value tolerance is wide by design; do not build a resonant circuit around the nominal inductance without checking the band.

    Frequently Asked Questions

    Can it be used in a switching converter?
    Yes, within its current and frequency range. Check the core loss at the switching frequency before assuming the DC rating is the limit.

    Why use a drum core rather than a molded part?
    More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.

    What is the rated current based on?
    A defined temperature rise from DC current. At higher ambient the thermal margin shrinks, so derate against the actual board temperature.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products