Eaton LD2-390-R 39.0 uH Metalized Inductor, Isat 1.85 A
Eaton LD2-390-R 39.0 uH Metalized Inductor, Isat 1.85 A

Eaton LD2-390-R 39.0 uH Metalized Inductor, Isat 1.85 A

Share
LD2-390-R: metalized drum core inductor, 39.0 uH, 2.42 A, Isat 1.85 A, DCR 160 mOhm.
    • Product Details
    • Download

    Eaton LD2-390-R 39.0 uH Metalized Inductor, Isat 1.85 A

    LD2-390-R at a glance: metalized drum core inductor, 39.0 uH, 2.42 A, Isat 1.85 A, DCR 160 mOhm.

    Electrical Specifications

    ParameterValue
    Orderable part numberLD2-390-R
    Inductance39.0 uH ±20%
    DCR maximum @ +25 °C160 mOhm
    Irms (DC, 40 °C rise)2.42 A
    Isat1.85 A
    MountingThrough-hole
    Operating temperature-40 °C to +125 °C
    QualificationCommercial grade
    RoHSCompliant, -R suffix
    Data sheetEaton Technical Data 4310

    Dimensions and Pad Layout

    LD2-390-R mechanical dimensions and pad layout

    Drawing reproduced from Eaton Technical Data 4310: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.

    How to Read These Ratings

    A metalized drum core inductor is a wound coil on a drum-shaped ferrite core, with the winding metalized or the core coated so the part can be handled and soldered. It gives more inductance per volume than a multilayer part at the cost of a larger body and a more open magnetic path.

    At 2.42 A the winding dissipates about 0.937 W in copper, using the 160 mOhm figure. That is the DC floor of the loss budget: ripple and core loss come on top of it.

    Saturation is reached at 1.85 A. Beyond that point the inductance falls on the soft part of the curve, and the converter’s ripple grows faster than the load current does.

    Within the LD2 family this is value 16 of 41, in a range that runs from 1 to 2200 uH.

    Positioning in the Range

    The drum core family covers about 1 µH to tens of microhenry in axial, radial and surface-mount bodies. It is the value range between the chip inductors and the large toroids.

    • The open magnetic path means nearby metal changes the inductance. Keep the specified clearance to shields and screws.
    • Typical applications: buck or boost inductor; noise filtering and output filter chokes; computers; power supplies; test equipment instrumentation smd device.
    • Design note: the value tolerance is wide by design; do not build a resonant circuit around the nominal inductance without checking the band.

    Frequently Asked Questions

    Why use a drum core rather than a molded part?
    More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.

    Can it be used in a switching converter?
    Yes, within its current and frequency range. Check the core loss at the switching frequency before assuming the DC rating is the limit.

    Is the part shielded?
    The drum concentrates flux in the core but the ends are open. Keep sensitive traces away from the axis of the part.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message

    Shenzhen Gaorunxin Technology Co., Ltd

    Related Products