
| Parameter | Value |
|---|---|
| Orderable part number | LD2-680-R |
| Inductance | 68.0 uH ±20% |
| DCR maximum @ +25 °C | 280 mOhm |
| Irms (DC, 40 °C rise) | 1.88 A |
| Isat | 1.35 A |
| Mounting | Through-hole |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 4310 |

Drawing reproduced from Eaton Technical Data 4310: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
The drum geometry concentrates the field in the core but leaves the ends open, so the inductance depends on the surroundings more than a shielded part would. That is acceptable in the applications these parts serve – filters, bias supplies, low current DC-DC stages – where the board is not densely packed.
At 1.88 A the winding dissipates about 0.99 W in copper, using the 280 mOhm figure. That is the DC floor of the loss budget: ripple and core loss come on top of it.
Saturation is reached at 1.35 A. Beyond that point the inductance falls on the soft part of the curve, and the converter’s ripple grows faster than the load current does.
Within the LD2 family this is value 21 of 41, in a range that runs from 1 to 2200 uH.
The drum core family covers about 1 µH to tens of microhenry in axial, radial and surface-mount bodies. It is the value range between the chip inductors and the large toroids.
What is the rated current based on?
A defined temperature rise from DC current. At higher ambient the thermal margin shrinks, so derate against the actual board temperature.
Is the part shielded?
The drum concentrates flux in the core but the ends are open. Keep sensitive traces away from the axis of the part.
Why use a drum core rather than a molded part?
More inductance per unit cost in the mid range, and a wider value selection. The trade is a more open magnetic path and a larger body.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd