
| Parameter | Value |
|---|---|
| Orderable part number | MFBM1V2012-301-R |
| Impedance @ 100 MHz | 300 Ohm |
| Impedance tolerance | ±25% |
| DCR maximum @ +25 °C | 80 mOhm |
| Rated current maximum | 2500 mA |
| Test frequency | 100 MHz |
| Test voltage | 50 mV |
| Package | 2.0 x 1.25 mm |
| Size code | 2012 (0805) |
| Mounting | Surface mount |
| Operating temperature | -55 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data 11112 |

Drawing reproduced from Eaton Technical Data 11112: outline with rated mm dimensions, pad layout and marking. Tolerances are stated on the drawing.
A ferrite bead is not an inductor in the usual sense: it is a lossy element. At low frequency it looks like a small resistance in series with the line; at the frequency where the ferrite absorbs, its impedance rises and the noise energy is converted into heat in the material rather than reflected back into the circuit.
At 100 MHz this bead presents 300 ohm with an allowed spread of ±25%, and its DC resistance is 80 mOhm maximum. At the rated 2500 mA that resistance drops 0.2 V, which is the figure to check against the rail tolerance.
Within the MFBM1V2012 family this is value 19 of 22, in a range that runs from 0 to 0 nH.
The ferrite bead family spans a few ohms to several hundred ohms at 100 MHz, in 0201 through 1206 bodies. Current ratings run from a few hundred milliamps in the small sizes to several amps in the larger ones.
How do I choose between MFBM and MFBW?
MFBM is the high-current series: lower impedance per size, higher rated current. MFBW is the high-impedance series for signal lines where DC current is small.
Does the bead dissipate the noise as heat?
Yes. The ferrite is lossy at the frequencies it absorbs, so the noise energy becomes heat in the material rather than being reflected back to the source.
What does the impedance tolerance mean?
It is the allowed spread around the nominal impedance. Low-value beads are specified as a range, for example 0 to 15 ohm, because a percentage tolerance at those values would be meaningless.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd