
| Parameter | Value |
|---|---|
| Orderable part number | MOVS4032V075 |
| Working voltage, RMS | 75 Vrms |
| Working voltage, DC | 102 Vdc |
| Varistor voltage at 1 mA | 108-132 V |
| Leakage current at 0.8 Vv | max. 50 uA |
| Clamping voltage, 8/20 us | 200 V at 10 A |
| Peak current, 8/20 us | 1200 A |
| Maximum energy, 10/1000 us | 7.8 J |
| Rated power | 0.25 W |
| Typical capacitance at 1 kHz | 400 pF |
| Component thickness | 4.2 mm |
| Package | 4032 |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +85 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, halogen free |
| Data sheet | Eaton Technical Data ELX1004 |
Dimensions, recommended pad or hole pattern and the derating curves are
on the data sheet pages; the package line above gives the body size as Eaton states it.
These parts are used where the board is assembled reflow-only and a radial disc would need a second process. The penalty is thermal: the chip has less mass than a disc of the same diameter, so the joule rating per unit area is lower.
The clamp column works out at 1.85 times the varistor voltage: 200 V at the rated current against 108~132 V at 1 mA. That ratio is what the downstream part has to survive, not the 108~132 V figure on the label.
Standing at 102 V the leakage is at most 50 uA, which is 5.1 mW of continuous dissipation. Small, but it is why a varistor on a battery rail has to be chosen on leakage and not only on voltage.
At 4.2 mm tall this is the part that has to fit under the enclosure. The 7.8 J rating and the 1200 A peak come from a body that size, so a lower profile in the same footprint would mean less energy.
Within the MOVS4032 family this is item 11 of 30 in the Eaton catalogue.
Place the chip directly across the connector pins with the ground return on the same layer. The part protects what is between its own terminals, so a shared ground path back to the connector defeats it.
Can it be reflow soldered?
Yes, that is the point of the package. The recommended profile and pad geometry are in the data sheet, and the pad is also the thermal path, so a reduced pad raises the body temperature.
What is the peak current rating for?
It is the 8/20 microsecond single-shot current the body survives. The energy column is the better guide for a long pulse, because a 10/1000 microsecond waveform delivers far more joules at the same peak.
Why is the capacitance so high?
A 4032 body at 14 Vdc has a large electrode area and a thin dielectric, so the capacitance runs into thousands of picofarads. That is fine on a supply rail and not fine on a data line.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd