
| Parameter | Value |
|---|---|
| Orderable part number | MOVS4032V320 |
| Working voltage, RMS | 320 Vrms |
| Working voltage, DC | 420 Vdc |
| Varistor voltage at 1 mA | 459-561 V |
| Leakage current at 0.8 Vv | max. 50 uA |
| Clamping voltage, 8/20 us | 845 V at 10 A |
| Peak current, 8/20 us | 1200 A |
| Maximum energy, 10/1000 us | 30 J |
| Rated power | 0.25 W |
| Typical capacitance at 1 kHz | 85 pF |
| Component thickness | 5.6 mm |
| Package | 4032 |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +85 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, halogen free |
| Data sheet | Eaton Technical Data ELX1004 |
Dimensions, recommended pad or hole pattern and the derating curves are
on the data sheet pages; the package line above gives the body size as Eaton states it.
A surface mount varistor puts the same zinc oxide body into a leadless chip so the protection sits next to the connector on an automated line. The absence of leads removes the inductance that slows a radial part, which matters when the transient has a fast edge.
The clamp column works out at 1.84 times the varistor voltage: 845 V at the rated current against 459~561 V at 1 mA. That ratio is what the downstream part has to survive, not the 459~561 V figure on the label.
Standing at 420 V the leakage is at most 50 uA, which is 21 mW of continuous dissipation. Small, but it is why a varistor on a battery rail has to be chosen on leakage and not only on voltage.
At 5.6 mm tall this is the part that has to fit under the enclosure. The 30 J rating and the 1200 A peak come from a body that size, so a lower profile in the same footprint would mean less energy.
Within the MOVS4032 family this is item 24 of 30 in the Eaton catalogue.
Place the chip directly across the connector pins with the ground return on the same layer. The part protects what is between its own terminals, so a shared ground path back to the connector defeats it.
Is the SMD part a drop-in for a radial disc?
Electrically it can be, at the same varistor voltage and energy. Mechanically it is not: the footprint, the height and the thermal path all change, and the SMD body has less mass to absorb the same pulse.
How much height does it add?
The thickness column is the body height above the board, 3.2 mm for the low profile parts and up to 5.6 mm for the high voltage ones. That has to clear the enclosure before the part is designed in.
Can it be reflow soldered?
Yes, that is the point of the package. The recommended profile and pad geometry are in the data sheet, and the pad is also the thermal path, so a reduced pad raises the body temperature.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd