Eaton RL1011-6R8-R 7.04 uH Radial Inductor, 4.03 A
Eaton RL1011-6R8-R 7.04 uH Radial Inductor, 4.03 A

Eaton RL1011-6R8-R 7.04 uH Radial Inductor, 4.03 A

Share
RL1011-6R8-R: radial leaded drum core inductor, 7.04 uH , 4.03 A Irms, Isat 5.64 A, DCR 23 mOhm.
    • Product Details
    • Download

    Eaton RL1011-6R8-R 7.04 uH Radial Inductor, 4.03 A

    RL1011-6R8-R at a glance: radial leaded drum core inductor, 7.04 uH , 4.03 A Irms, Isat 5.64 A, DCR 23 mOhm.

    Electrical Specifications

    ParameterValue
    Orderable part numberRL1011-6R8-R
    Inductance7.04 uH
    DCR typical @ +20 °C23 mOhm
    Irms (DC, 40 °C rise)4.03 A
    Isat5.64 A
    SRF typical25 MHz
    MountingThrough-hole
    Operating temperature-40 °C to +125 °C
    QualificationCommercial grade
    RoHSCompliant, -R suffix
    Data sheetEaton Technical Data 10278

    Outline Drawing

    RL1011-6R8-R mechanical dimensions and pad layout

    Drawing reproduced from Eaton Technical Data 10278: outline with
    rated mm dimensions, pad layout and marking.

    The Figures Explained

    This is a through-hole drum core choke: ferrite drum, wound coil, heat-shrink sleeve, tinned leads. The value range runs from a few microhenry into the millihenry region.

    At 4.03 A the winding dissipates about 0.374 W in copper using the typical DCR of 23 mOhm. That is the DC floor of the loss budget – ripple and core loss come on top.

    The core stores about 112 uJ at the saturation point, which is the energy available to bridge a load step.

    Self-resonance is 25 MHz typical. Keep the operating band, and the harmonics that carry energy, below it.

    Within the RL1011 family this is value 2 of 19, in a range from 4.43 uH to 2204 uH.

    Series Positioning

    The RL family is the radial leaded drum core range: through-hole parts with a protective sleeve, covering microhenry to millihenry values.

    • The leads and the plated holes are part of the current path. Check them, not just the winding, against the rated current.
    • Typical applications: led drivers and lighting; utility meters; appliance electronics; motor drives; power supplies.
    • Design note: leave clearance around the part for the sleeve and for the field. The inductance depends on nearby metal.

    Frequently Asked Questions

    Why a sleeve over the winding?
    It protects the coil during handling and gives the part a defined outside diameter for automated placement.

    Is the part shielded?
    No. The drum is open at the ends, so keep sensitive traces away from the axis.

    Can it be used in a switching supply?
    Yes, at the switching frequencies its core loss allows. Compare the core loss curve before assuming the DC rating is the limit.

    Shenzhen Gaorunxin Technology Co., Ltd

    Online message