
| Parameter | Value |
|---|---|
| Orderable part number | SDCL1V4030-6R8M-R |
| Inductance | 6.8 uH ±20% |
| FLL minimum (at Isat) | 3.54 uH |
| DCR typical @ +20 °C | 100 mOhm |
| DCR maximum @ +20 °C | 115 mOhm |
| Irms (DC, 40 °C rise) | 1.6 A |
| Isat | 2.8 A |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data ELX1032 |

Drawing reproduced from Eaton Technical Data ELX1032: outline with
rated mm dimensions, pad layout and marking.
Semi-shielded construction is a compromise that works: enough magnetic material around the coil to keep radiated emissions low, but an open enough structure to keep the DCR and the cost down. Common on consumer and industrial DC-DC rails.
At 1.6 A the winding dissipates about 0.256 W in copper using the typical DCR of 100 mOhm. That is the DC floor of the loss budget – ripple and core loss come on top.
The core stores about 26.7 uJ at the saturation point, which is the energy available to bridge a load step.
Within the SDCL1V4030 family this is value 7 of 17, in a range from 0.68 uH to 470 uH.
The SDC family is the semi-shielded range: low-profile SMD inductors from about 2 mm to 6 mm, aimed at compact DC-DC converters where a full shield is not needed.
Is the inductance stable with temperature?
The tolerance is quoted over the operating range; the drift inside that band is small for a wound ferrite part.
Why quote both Irms and Isat?
Because they describe different failure modes: overheating and saturation. A design has to satisfy both.
Is the inductance stable with temperature?
The tolerance is quoted over the operating range; the drift inside that band is small for a wound ferrite part.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd