
| Parameter | Value |
|---|---|
| Orderable part number | UP1B-330-R |
| Rated inductance | 33 uH ±20% |
| OCL (open circuit inductance) | 36 uH ±20% |
| Irms (40 °C rise, no core loss) | 0.82 A |
| Isat (peak, rolloff per data sheet) | 0.99 A |
| DCR typical @ +20 °C | 367 mOhm |
| Package | Four body sizes in this data sheet – see drawing |
| Mounting | Surface mount |
| Operating temperature | -40 °C to +125 °C |
| Qualification | Commercial grade |
| RoHS | Compliant, -R suffix |
| Data sheet | Eaton Technical Data DS4308 |

Drawing reproduced from Eaton Technical Data DS4308: outline views
with rated mm dimensions, pad layout and marking.
This is a drum core choke chosen for DC-DC converters, filters and bias supplies where the board has room and the field is not the limiting factor. Irms is the thermal limit, Isat the magnetic one, and on the higher values the core saturates long before the winding overheats.
Copper loss at the 0.82 A rating is about 0.247 W with the typical DCR of 367 mOhm. Ripple current adds to that through the AC resistance.
The core holds about 16.2 uJ at the saturation point, which is the energy available to bridge a load step before the inductance collapses.
Within the UP1B family this is value 11 of 17, in a range from 0.47 to 330 uH.
The UP family runs from 0.47 uH to 1000 uH in bodies from 6.6 x 4.45 mm up to 18.54 x 15.24 mm, all unshielded drum core, all with the saturation and thermal ratings quoted separately.
How far does the field reach?
The drum is open at both ends, so the field leaves along the axis and returns around the body. Keep traces and vias out from under the part and keep sensitive nodes off the axis. A shielded part is the answer when that is not possible.
Is the saturation current defined at 20 % or 30 % rolloff?
It varies by data sheet. The rolloff point is stated in the note under the table of each document; the number on this page is the one printed for this part, not a normalised figure.
How far does the field reach?
The drum is open at both ends, so the field leaves along the axis and returns around the body. Keep traces and vias out from under the part and keep sensitive nodes off the axis. A shielded part is the answer when that is not possible.
Shenzhen Gaorunxin Technology Co., Ltd
Shenzhen Gaorunxin Technology Co., Ltd