KDS DSO753SD SPXO MHz 13.5–212.5 MHz 7.3x4.9x1.7 Crystal Oscillator

KDS DSO753SD SPXO MHz 13.5–212.5 MHz 7.3x4.9x1.7 Crystal Oscillator

The DSO753SD SPXO brings 13.5–212.5 MHz reference to FPGA and DSP timing references and PCIe and serializer-deserializer clocks circuits in a 7.3x4.9x1.7 SMD package. With see datasheet supply and Industrial operating range, it covers most embedded and industrial timing needs.

Why Choose This Rating

• see datasheet supply envelope compatible with mainstream 1.8V/2.5V/3.3V rails
• Tight supply-pushing and load-pulling for predictable frequency behavior
• 13.5–212.5 MHz fundamental reference in a compact 7.3x4.9x1.7 SMD package
• Compatible with mainstream oscillator footprints and land patterns
• Low phase noise and tight frequency stability across Industrial temperature range
• Industry-standard 7.3x4.9x1.7 footprint for drop-in replacement across designs

Core Specifications

Best-Fit Applications

• FPGA and DSP timing references
• PCIe and serializer-deserializer clocks
• Industrial wireless and timing-critical embedded designs
• FPGA and DSP timing references with strict frequency accuracy and stability

Selection Guidance

For FPGA and DSP timing references designs, confirm the DSO753SD frequency stability and phase-noise profile against your receiver acquisition window. The see datasheet supply envelope supports direct interface with common logic families, and the 7.3x4.9x1.7 footprint simplifies PCB layout in dense timing chains.

Validate the start-up time and steady-state current draw against your power budget, and confirm the supply-pushing and load-pulling behavior under realistic decoupling conditions. For temperature-sensitive deployments, review the KDS datasheet's stability vs. temperature plot over the full Industrial envelope.

Frequently Asked Questions

How does the DSO753SD differ from other KDS SPXO parts?
The DSO753SD uses the 7.3x4.9x1.7 SMD package with 13.5–212.5 MHz output. Compare against other package sizes and frequency points to find the best fit for your board layout.

Can the DSO753SD be used as a direct replacement for similar parts?
In many cases yes. The 7.3x4.9x1.7 package and standard 4-pad layout support drop-in replacement across manufacturers. Verify pin-out and supply voltage before substitution.

What is the typical phase noise of the DSO753SD?
Phase noise depends on the output frequency and offset. Refer to the KDS datasheet for the DSO753SD time-domain and phase-noise plots at the frequencies of interest.

Ordering and Packaging

Series reference: The KDS SPXO DSO753SD family covers a 13.5–212.5 MHz reference in a 7.3x4.9x1.7 SMD package. For other frequencies, package sizes, or stability grades, browse the full KDS SPXO product line.

Ordering reference: start with DSO753SD and confirm the exact reel size, termination finish, and compliance suffix against current stock before purchase.

Design note: Specifications are nominal and based on manufacturer datasheets. Verify the latest KDS data and curves before final release.