MPM54522GPC-0000-Z 3-16V, 6A Power Module

MPM54522GPC-0000-Z 3-16V, 6A Power Module

The MPM54522 is a dual 6A power module that integrates two high-efficiency, step-down DC/DC converter ICs, two inductors, and selected passive components onto a single over-molded package.

Key Specifications

Features

• Wide 3V to 16V Input Voltage (VINx, where x = 1 or 2) Range
• Dual 6A and Up to 12A for Parallel Operation
• MODE Pin to Select Output Voltage (VOUTx, where x = 1 or 2), Parallel Mode, and Timing via Pin-Strapping
• Remote Sense for Both Output Channels
• Configurable 500mA-Rated Low-Dropout (LDO) Regulator with Input Voltage Up to 3.6V
• Configurable Soft Start, Soft Shutdown, and Delay with MPS-Patented FLEX-Timer Sequence Control
• Configurable Reference Voltage (VREF) and Slew Rate
• Configurable Switching Frequency (fSW): 500kHz, 750kHz, 1MHz, and 1.25MHz
• Accurate VOUT and VIN Telemetry
• Open-Drain Power Good (PG) Indication and General Status Interrupt

Typical Application Circuit

Applications

• Storage and Networking
• FPGA and ASIC Power Supply

Design Notes

• Place the input capacitor across the module pins, not at the far end of a trace — the module's internal loop assumes a local source.
• Heat leaves through the module base and pins; the host board copper is part of the thermal solution.
• Measure output ripple with a short ground spring at the output pins; a long scope ground lead picks up switching noise that is not really there.
• For isolated variants, respect the creepage and clearance the safety standard demands across the isolation barrier.

Common Questions