MPM54532GPB-0000-T 2.9-16V, 6A Single 12A Power Module

MPM54532GPB-0000-T 2.9-16V, 6A Single 12A Power Module

The MPM54532 is a dual 6A power module that integrates a high-efficiency, step-down DC/DC converter IC, two inductors, and selected passive components in an over-molded package.

Key Specifications

Features

• 2.9V to 16V Input Voltage (VIN) Range
• 0.3V to 1.8V Output Voltage (VOUT) Range
• Dual 6A and Up to 12A for Parallel Mode
• MODE Pin to Select VOUT, Parallel Mode, and Timing via Pin-Strapping
• Remote Sense for Both Output Channels
• Configurable, Typically 500mA-Rated Low- Dropout (LDO) Regulator with Input Voltage Up to 3.6V
• Configurable Soft Start, Soft Shutdown, and Delay with FLEX-Timer Sequence Control
• Configurable Reference Voltage (VREF) and Slew Rate
• Configurable Switching Frequency (fSW): 500kHz, 750kHz, 1MHz, and 1.25MHz
• Accurate VOUT, Output Current (IOUT), and Junction Temperature (TJ) Telemetry

Typical Application Circuit

Applications

• Storage and Networking
• FPGA and ASIC Power Supplies

Design Notes

• Place the input capacitor across the module pins, not at the far end of a trace — the module's internal loop assumes a local source.
• Heat leaves through the module base and pins; the host board copper is part of the thermal solution.
• Measure output ripple with a short ground spring at the output pins; a long scope ground lead picks up switching noise that is not really there.
• For isolated variants, respect the creepage and clearance the safety standard demands across the isolation barrier.

Common Questions